Which commands are required to resolve this problem?

Refer to the exhibit.


The network administrator has created a new VLAN on Switch1 and added host C and host D. The administrator has properly configured switch interfaces FastEthernet0/13 through FastEthernet0/14 to be members of the new VLAN. However, after the network administrator completed the configuration, host A could communicate with host B, but host A could not communicate with host C or host D.
Which commands are required to resolve this problem?
A. Router(config)# interface fastethernet 0/1.3Router(config-if)#encapsulation dot1q 3Router(config-if)# ip address
B. Router(config)# router ripRouter(config-router)# network network network192.168.3.0
C. Switch1# vlandatabaseSwitch1(vlan)# vtp v2-modeSwitch1(vlan)# vtp domain ciscoSwitch1(vlan)# vtp server
D. Switch1(config)# interface fastethernet 0/1Switch1(config-if)# switchport mode trunkSwitch1(config-if)# switchport trunk encapsulation isl

Pass Cisco CCNA 200-301 Exam in First Attempt

FULL Printable PDF and Software. VALID exam to help you pass.


Leave a Reply

Your email address will not be published.

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.